Content

R1200GS "Crud Catcher" / Spray Guard
- to be or not to be?

By AndyW May2007

Many people ditch the "crud catcher" (BMW refer to it as a Spray Guard) on the back of the R1200GS because they don't like the look?!  Personally, as far as appearance goes I don't mind it that much, it fits in well with the GS's slightly 'quirky' appearance. As for function, it does a superb job of reducing spray from wet roads and dirt thrown up over the back end of the bike from the tyre. And so to me it makes no sense to ditch it.
Replacing it with a hugger is a compromise - sure a hugger gives great protection to the rear suspension and mid section of the bike but alone it's no substitute for the "crud catcher"

I've not seen or heard of anyone else that has done this to date but I decided on fitting a hugger AND keeping the Spray Guard / "crud catcher".  Ordinarily, certainly with the mounting method used for the Motorrad Concepts hugger, there is no scope for keeping the "crud catcher". However, some carful adaptation of the "crud catcher" with the trusty Dremel and a small hole drilled through the alloy hugger mounting bracket to take a small bolt and hey presto!.............
NB: Of course there is a caution to note - a replacement "crud catcher" may be required if you change huggers or on selling the bike wish to take the hugger off and return the bike to stock setup.

A question of taste possibly but one time where personally I prefer function over form!

R1200GS hugger AND

R1200GS

Tightening torques
Spray guard to rear wheel drive
M6 x 20 (3 torx bolts)
8 Nm     (Loctite 243)
Tightening torques
Brake caliper, rear, to cover of final drive housing
M8 x 25 (2 torx bolts)
24 Nm

And the adaptations to the mounting section of the "crud catcher"

Reshaping of mounting section - from above

Reshaped mounting section - inside

....and shots of an unmodified splash guard for comparison

Stock / unmodified R1200GS splash guard

Stock / unmodified R1200GS splash guard view 2

 

Comment on this article:
Found an error, noticed an omission, think any other change should be made or
just want to leave feedback? Please contact AndyW  Thank you

Contributions towards the running costs of this website will be very much appreciated.

Top of page